We have been listening to your feedback – and here is what some of you always wanted. We now have a symbol view of the schematic. What’s more – you can switch between the symbol view and the real view – using the button under the Run Button.

Schematic Symbol View

Symbol View

Once you click the Resistor Button under Run, the view will change to a real view and vice versa. The default view is now the symbol view.

Schematic Real View

Real View

Also note that while switching between symbol view and real view, if the sizes of the components are not consistent, some wires may disconnect. DoCircuits will flag this out if it happens. Finally, a meme to end this on a fun note. Enjoy the View !Switching between Symbol view and Schematic View