Hey everybody!! We at DoCircuits are bent on proving wrong all those that feel that electronics is boring and only for the nerds. As a result we will keep adding new features to make learning electronics easy and intuitive. Well how many of you had that feeling “What do I do after I land up on the Circuit Editor” ? “Or what am I to do next in this thing after dragging some components?” while Doing Circuits. You would have felt “do I have to read the Help section to know thoroughly what to do next?”

Well you will have something to guide you on how to build, run and share circuits from now on. We have introduced a feature called Workflow. Now every time you open our virtual lab a small window appears on right hand side of the screen.

 

The workflow window

There are three parts to it: build, run and analyze. And under each section you will find a set of instructions in red. Just follow what is given in them in order. As you complete the step the instruction turns green. Then you can go to the next step.

 

After completing a task

Complete each step until the plotter opens up showing the waveform plots. To know what to do next after plotting, close the plotter and see the workflow again.

 

After completing the workflow you will get some options on what to do next

You will have some options from which you can choose – like saving the circuit or sharing it – or to start building a new circuit.

Now those who found Doing Circuits slightly discomforting or new, now have a feature to assist them. Try it and give your comments!